![]() But it is likely that Skil recommends replacing the two gearbox bearings as part of the procedure. ![]() It plows through lumber in admirably hasty fashion, but. Introduced in the 1930s, the 77 is time-tested. ![]() Note: I've done this type of replacement a number of times on Skil circular saws without replacing the bearings on the gearbox side and not had any long term problems. Skilsaw chose its venerable Model 77 worm-gear saw as the basis for the Super Sawsquatch. This will pull the armature through the gearbox until it stops when the armature shoulder contacts the inner bearing race on the armature side of the gearbox. Reinstall nut and carefully tighten with impact driver. Slide new armature into the gearbox housing.ĩ. Install new bearing on commutator side of new armature using a simple jig to hold the armature.Ĩ. Press or drive armature out of gearbox brearing.ħ. Its not heavy duty, but its not super light. Remove saw guide plate and front housing.Ħ. Skilsaw just released a corded reciprocating saw with anti-vibration technology thats been receiving very. Remove nut behind plastic plug with impact driver while holding down while holding down saw blade stop.Ħ. Remove large plastic plug from rear of sawĥ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |